Programming your system correctly is an essential step to ensuring you recieve filtered water. This article is a concise version of the Programming Instructions found in your manual.
Set the Present Time
1.Tap the Program button once the set the Present Time. Use the Up and Down arrows to adjust the time on the screen.
Days Between Recharges
2.Tap Program button again to set the number of days between recharges. The default value is 14 days.
3.Change this setting by using the up and down arrows. If you have a high value of sediment or chlorine, the number of days should be closer together, meaning the unit will clean itself more often.
Recharge Time
4.Press Program again to display the Recharge Time. This what time the system will run through the cleaning cycle. The default value is 1:00 AM.
Backwash and Rinse Times
5.Hold the Program button until '000' appears, then let go. Tap the Program button again to display the Backwash Time (in minutes). The default value is 2 minutes. If you have high concentrations of Chlorine or Sediment, you can increase this value with the Up arrow.
6.Tap the Program button again to display the Rinse Time (in minutes). The default is 1 minute. If you have high concentrations of Chlorine or Sediment, you can increase this value with the Up arrow.
NOTE:This unit drains at a rate of 3.4 gallons/min. The water usage during a recharge with the default values is about 10-12 gallons of water.
7.Tap the Program button once to return to the home screen.